Print The Porto

A collection of tips about 3d printing.

September 2015

Posts 1 to 2 of 2

0

Notes on printing with Ninjaflex

Always use at least a minimum of 30% infill, the higher the better. Print at a slow speed: 20-30mm/sec (1200-1800mm/min for simplify3d). Extrude at a temperature between: 210-225°C. Not really needed, but you can have the platform bed temperature set to: 20-50°C. To reduce stringiness, set retraction for 1.75mm filament, to 2-3mm. Go with the lower amount if using an Ed3. Another option is to turn on the… View More

0

Purge and nozzle wipe starting gcode

Use this gcode to purge and wipe filiment before printing. Simplified version M107 ;turn off fan G28 X0 Y0 Z0 ;home X, Y and Z axis end-stops G29 ;initiate z-probing G1 X0 Y0 Z.10 ;move to corner of bed G92 E0 ;zero the extruded length G1 F200 E3 ;extrude 3mm of feed stock G92 E0 ;zero the extruded length Advanced wipe and purge M107 ;turn off… View More