Print The Porto

A collection of tips about 3d printing.

September 2016

Posts 1 to 2 of 2

0

How to save a print that is losing supports

I was recently reading though the 3D Printing group on facebook when one of the members, Ken Jones, posted an amazing trick to save a print when the support structure falls off. Just use putty or clay to hold it in place. … View More

0

How to calibrate your 3d printer for accurate printing

Most people don't realize it, but you can get reasonably accurate prints with just about any 3D Printer, even with low-end clones. With a little bit of time and measuring, prints can be within .05mm accuracy. Having an uneven X and Y is where a 20mm cube will print 20.5mm on the X-axis and 19.95mm on the Y-Axis and cause circles to be over or under-sized and eleptical. Most machines will come with preset steps configured, based off of… View More