Print The Porto

A collection of tips about 3d printing.

Filament

Posts 1 to 2 of 2

0

Notes on printing with Ninjaflex

Always use at least a minimum of 30% infill, the higher the better. Print at a slow speed: 20-30mm/sec (1200-1800mm/min for simplify3d). Extrude at a temperature between: 210-225°C. Not really needed, but you can have the platform bed temperature set to: 20-50°C. To reduce stringiness, set retraction for 1.75mm filament, to 2-3mm. Go with the lower amount if using an Ed3. Another option is to turn on the… View More

0

Printing Ninjaflex TPU filament on the E3D titan extruder

I recently upgraded my eclips3d printer to use an E3D Titan extruder, which has been printing out pretty great once I dialed in all the settings. I needed to print a bunch of rubbery feet for a wire shelf. In the past I've used my printrbot simple to print with ninjflex, so I was curious to try the titan since it is… View More